Intel® Fortran Compiler 17.0 Developer Guide and Reference
The RECL specifier indicates the length of each record in a file connected for direct access, or the maximum length of a record in a file connected for sequential access.
The RECL specifier takes the following form:
RECL = rl
rl |
Is a positive numeric expression indicating the length of records in the file. If necessary, the value is converted to integer data type before use. |
If the file is connected for formatted data transfer, the value must be expressed in bytes (characters). Otherwise, the value is expressed in 4-byte units (longwords). If the file is connected for unformatted data transfer, the value can be expressed in bytes if compiler option assume byterecl is specified.
Except for segmented records, the rl is the length for record data only, it does not include space for control information. If rl is too large, you can exhaust your program's virtual memory resources trying to create room for the record.
The length specified is interpreted depending on the type of records in the connected file, as follows:
For segmented records, RECL indicates the maximum length for any segment (including the four bytes of control information).
For fixed-length records, RECL indicates the size of each record; it must be specified. If the records are unformatted, the size must be expressed as an even multiple of four.
You can use the RECL specifier in an INQUIRE statement to get the record length before opening the file.
For variable-length records, RECL indicates the maximum length for any record.
If you read a fixed-length file with a record length different from the one used to create the file, indeterminate results can occur.
The maximum length for rl depends on the record type and the setting of the CARRIAGECONTROL specifier, as shown in the following table:
Record Type |
CARRIAGECONTROL |
Formatted (size in bytes) |
|---|---|---|
Fixed-length |
'NONE' |
2147483647 (2**31-1) 1 |
Variable-length |
'NONE' |
2147483640 (2**31-8) |
Segmented |
'NONE' |
32764 (2**15-4) |
Stream |
'NONE' |
2147483647 (2**31-1) |
Stream_CR |
'LIST' |
2147483647 (2**31-1) |
'FORTRAN' |
2147483646 (2**31-2) |
|
Stream_LF |
'LIST' |
2147483647 (2**31-1) 2 |
'FORTRAN' |
2147483646 (2**31-2) |
|
1Subtract 1 if compiler option vms is used. 2 L*X only |
||
The default value depends on the setting of the RECORDTYPE specifier, as shown in the following table:
RECORDTYPE |
RECL value |
|---|---|
'FIXED' |
None; value must be explicitly specified. |
All other settings |
132 bytes for formatted records; 510 longwords for unformatted records.1 |
1To change the default record length values, you can use environment variable FORT_FMT_RECL or FORT_UFMT_RECL. |
|
For formatted records with other than RECORDTYPE='FIXED', the default RECL is 132.
There is a property of list-directed sequential WRITE statements called the right margin. If you do not specify RECL as an OPEN statement specifier or in environmental variable FORT_FMT_RECL, the right margin value defaults to 80. When RECL is specified, the right margin is set to the value of RECL. If the length of a list-directed sequential WRITE exceeds the value of the right margin value, the remaining characters will wrap to the next line. Therefore, writing 100 characters will produce two lines of output, and writing 180 characters will produce three lines of output. You can turn off the right margin using the wrap-margin compiler option or the FORT_FMT_NO_WRAP_MARGIN environment variable.